Skip to main content

Knots and bows

Comments

1 comment

  • BW Forum Team

    Hi there David, 

    When creating a tie/bow or knot in the software, we will need to use a combo of internal lines and shrink to create the look of this effect.

    Physically tying the pattern pieces as we would in real life, is currently not possible in 3D. The system recognized where a pattern sits based on the 3D layer it is assigned. Since we cannot specify the layering in more detail, the system will always see the knot as a collision or tangle and untie it.

    Please see below the recommended steps for creating a tie or bow:
    Good luck, 

    Zisie

    0

Please sign in to leave a comment.