Skip to main content

Send to Floor

With effect from 2020 September Edition, this feature has been superseded and is no longer available.

The Send to Floor feature is a Labs feature that simulates the garment on a flat surface, without the avatar - like laying the garment on a tabletop.

To use the Send to Floor feature:

  1. In Lotta or VStitcher, load the garment.

    If the garment is not already dressed, on the Main toolbar, click Dress, then after a suitable time, click Finish.

  2. On the Main Menu, click Garment, then Labs. Then click Send to Floor. In the 3D window, the avatar is no longer displayed.

  3. On the Main toolbar, click Dress, then after a suitable time, click Finish. The garment is at the bottom of the 3D window.

  4. Right-click the garment, then click Look At. Use your mouse to navigate the window so the garment displays as required.

    Send to floor

  5. To exit the feature:

    1. In the 3D window, right-click away from the garment, then click Show Avatar.

    2. On the Main toolbar, click Snapshots, then click a suitable snapshot.

© Browzwear Solutions Pte. Ltd. 2018-2021. All rights reserved. Legal Notices

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section