Skip to main content

Creating a Base Piece

To create a base piece:

  1. Ensure you have saved all work in DB Admin, then close DB Admin.

  2. In VStitcher, on the Main menu, click File, then New Garment.

  3. On the Resources tabs, click 3D.

  4. On the 3D tab, click Avatars.

  5. In Avatars, locate and double-click the avatar Sphere_Materials_Avt.

    Sphere_Materials_Avt

    The avatar loads in the 3D window.

    Avatar in 3D window

  6. On the Main toolbar, click Insert.

    insert.jpg

  7. Click Ellipse.

    Insert Ellipse

  8. In the 2D window, drag to create a pattern piece. A size of 89 x 89 cm (35 x 35 in)is recommended.

  9. On the Main toolbar, click Arrange.

    Arrange

  10. Put the piece in the Shoulders cluster (marked by ^ icons on the front figure).

    Shoulders cluster

    The Shoulders cluster places the piece parallel to the ground, allowing it to drape over the fabric testing avatar.

  11. On the Main toolbar, click Prepare.

    Prepare

  12. In the 3D window, reposition the piece as required so the piece sits above the avatar.

    Prepare the piece

  13. Save the file: on the Main toolbar, click Save.

© Browzwear Solutions Pte. Ltd. 2018-2021. All rights reserved. Legal Notices

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section