To replace a part:

1. If the Materials tab is not already open, on the Resources tabs, click Materials.

   

2. On the Materials tab, in the Trims section, in Edge Assignable, hover over the zipper image.

   

   You can click the “X” icon to delete the zipper. The “X” icon is replaced by a “-” icon if the zipper has been assigned to a line or edge. Click the “-” icon to remove the zipper from the lines or edges to which it has been assigned.

3. Click . A menu is displayed.

   

4. Click Look Inside to view the zipper parts. The zipper parts are displayed in a pop-up pane.

   

5. On the part you want to replace, click . A menu is displayed.

6. Click Replace. A file explorer window is displayed.

7. Navigate to the location of the replacement part and select it.

8. Click Open. The old part is replaced with the new part.

Dragging to Replace a Zipper Part

In addition, you can replace zipper parts by dragging a seam or fabric from the Resources tabs to the zipper. If you do this, a pop-up pane is displayed asking you to select the part you want to replace.

You can only select only eligible parts . For example, if you drag a seam, you can only select Teeth - Closed or Teeth - Open. The following table summarizes the eligible parts.

To extract a copy of a part:

1. If the Materials tab is not already open, on the Resources tabs, click Materials.

   

2. On the Materials tab, in the Trims section, in Edge Assignable, hover over the zipper image.

   

3. Click . A menu is displayed.

   

4. Click Look Inside to view the zipper parts. The zipper parts are displayed in a pop-up pane.

   

5. On the part you want to extract, click . A menu is displayed.

6. Click Extract a Copy. A copy of the part is made and is displayed in the appropriate part of the Materials tab. For example, if you extract a copy of a Teeth - Open part, it is displayed in the Seams section. The following table summarizes the locations of extracted copy parts.

   Zipper Part	Copy Extracted To
   Puller	Trims - Piece Assignable
   Pull Cord	Trims - Piece Assignable
   Teeth - Closed	Seams
   Teeth - Open	Seams
   Stopper	Trims - Piece Assignable
   Tape	Fabrics

You can edit the following zipper parts in external software:

• Teeth - Closed

• Teeth - Open

• Tape

To edit a zipper part:

1. If the Materials tab is not already open, on the Resources tabs, click Materials.

   

2. On the Materials tab, in the Trims section, in Edge Assignable, hover over the zipper image.

   

3. Click . A menu is displayed.

   

4. Click Look Inside to view the zipper parts. The zipper parts are displayed in a pop-up pane.

   

5. On the part you want to extract, click . A menu is displayed.

6. Click Edit Externally. The part is opened up in your default graphics software.