Length Sample - Long Segment Test
There are the following tests for the length sample:
Long segment test
Short segment test
To run the long segment test:
If not already at the FAB user interface, start the FAB, open DB Admin, and click Use FAB. For more information, refer to Using the FAB.
-
On the list on the left side of the page, click Length - Long Segment.
-
At Enter fabric width, type in the sample width. (The default is 5 cm.)
Remove any sample fabric from the machine.
Click Start. The movable clamp moves into place.
-
Slide the square block between the clamps. The grooved edge should face the movable clamp.
Position the fabric sample on the FAB according to Positioning Fabric for Long Segment Tests.
Remove the block.
-
Click Start.
The test is complete when two blue ticks are displayed on the right side of the page.
Click Next.
Comments
Please sign in to leave a comment.