Pintucks

This video was recorded using version 2021.1.

When adding a pintuck, here are some important points to note:

• There must be enough fullness for the pintucks. You can use the Slash and Spread feature to adjust the fullness.

• Add three internal lines to create one pintuck. The center line is the folded line of the pintuck.

• To create a crease, use the Iron property on the line.

• Stitch the other two lines after the crease has been simulated.

• Lower the grid size for a smoother crease.

• To stitch down part of the pintuck:

  • Create an internal line to stitch part of the middle crease line of the pintuck to.

  • Stitch the internal line to the crease line and adjust the stitch measurements to match.