Skip to main content

Editing the Connectors

  You can edit the connectors of a 3D object in VStitcher and Lotta. To edit the connectors: If the Materials tab is not already ope...

Updated over 2 weeks ago
LT.svg
VS.svg

You can edit the connectors of a 3D object in VStitcher and Lotta.

To edit the connectors:

  1. If the Materials tab is not already open, on the Resources tabs, click Materials.

    • Lotta

      materials.png

    • VStitcher

      materials.png

  2. Click the 3D object. Details of the object are displayed in the Context view.

    edit-1.png

  3. In the Context view, click the image that is displayed in the 3D Trim section.

    edit-2.png

    The 3D Object Editor is displayed.

    edit-3.png

    Tip

    Click

    expand.png

    to expand the editor.

    edit-5.png

    The connectors display as a white circle. If you cannot see them on the editor, press Alt and drag to change the view of the object.

  4. In the 3D Object Editor, click Connectors.

  5. To delete a connector, click the X that is displayed to the right of its XYZ position.

    edit-4.png

  6. To add a connector:

    1. Click Point.

    2. Click on the object where you want the connector to be.

  7. Close the 3D Object Editor.

  8. If you remove or edit connectors for an object that has already been assigned, it is recommended to assign the object again.

Note

Add more then a single connector to ensure a stable orientation of the 3D trim during 3D simulation. Two connectors assigned in different locations will be sufficient for most 3D trims.

Related Articles
Editing 3D Object Colors
Importing 3D Objects - Overview
Did this answer your question?