1. Browzwear Help Center
  2. Fabric Analyzer
  3. FAB 1.0
  4. Running the Tests

Width Sample - Long Segment Test

Susan Kehila
Updated

There are the following tests for the width sample:

  • Long segment test

  • Short segment test

To run the long segment test:

  1. If not already at the FAB user interface, start the FAB, open DB Admin, and click Use FAB. For more information, refer to Using the FAB.

  2. On the list on the left side of the page, click Width - Long Segment.

    WLS.png

  3. At Enter fabric width, type in the sample width. (The default is 5 cm.)

    wls-1.png

  4. Remove any sample fabric from the machine.

  5. Click Start. The movable clamp moves into place.

  6. Slide the square block between the clamps. The grooved edge should face the movable clamp.

    long-seg-2.png

  7. Position the fabric sample on the FAB according to Positioning Fabric for Long Segment Tests.

  8. Remove the block.

  9. Click Start.

    The test is complete when two blue ticks are displayed on the right side of the page.

    WLS-2.png

  10. Click Next.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

See more